Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

LPile Loads

Status
Not open for further replies.

RyUIUC

Structural
Joined
Sep 21, 2011
Messages
16
I am analyzing a single pile using LPile V.5 using analysis Type 1- Computation of Pile Response Using Elastic Pile Stiffness (Basic Modeling). In trying to determine the maximum factored bending/shear forces along the pile length, are you supposed to enter in factored loads to determine these values directly from the output report/graphics or are you supposed to input unfactored loads and factor the results?

If factored loads are used, does a seperate run have to be performed for unfactored loads to determine an accurate deflection?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top