Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Looking for large worm and wheel with quad thread 1

Status
Not open for further replies.
Intermesher

Intermesher

New member
Joined
Jun 6, 2001
Messages
179
Location
CA
Does anyone know of a supplier that offers quad-thread worm & wheels that are larger (stronger) than a 6 diametral pitch? The required ratio is approximately 7.5:1.

Thanks;


 
Sort by date Sort by votes
Look for any supplier that offers you a 7.5:1 ratio and has a 5" or more distance between input shaft and output shaft those sure are larger than 4 DP (which should be around 3 to 3.5" between shafts).

Regards

SACEM1
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

V
  • Locked
  • Question Question
Mutilated Worm Drive for Intermittent Cam
2
Replies
22
Views
9K
vne147
V
rQuestionEngineering
  • Locked
  • Question Question
Leveling requirement for bevel gear driving compressors in marine and land
Replies
1
Views
1K
mfgenggear
mfgenggear
Alice24
  • Locked
  • Question Question
Worm gearbox question (video included)
Replies
2
Views
506
Alice24
Alice24
B
  • Locked
  • Question Question
Involute Rack and Sector Pinion Gear Question
Replies
5
Views
2K
mfgenggear
mfgenggear
T
  • Locked
  • Question Question
Can gears mesh with different operating pressure angle?
Replies
7
Views
4K
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top