Golden State EE
Electrical
Hello everyone,
We are planning to install Current Limiting Protector (CLiP) devices at our substation and are looking for any industry standards or references that explicitly recommend or recognize the use of current-limiting devices to reduce fault current. I looked through IEEE 242 (Buff Book) and IEEE 141 (Red Book) but haven’t been able to locate a specific clause or section that clearly addresses this.
If anyone can point me to the applicable standard references, white papers, or technical documentation that support the use of CL devices in medium voltage systems for fault current mitigation, I’d greatly appreciate it.
Thanks in advance for your help!
We are planning to install Current Limiting Protector (CLiP) devices at our substation and are looking for any industry standards or references that explicitly recommend or recognize the use of current-limiting devices to reduce fault current. I looked through IEEE 242 (Buff Book) and IEEE 141 (Red Book) but haven’t been able to locate a specific clause or section that clearly addresses this.
If anyone can point me to the applicable standard references, white papers, or technical documentation that support the use of CL devices in medium voltage systems for fault current mitigation, I’d greatly appreciate it.
Thanks in advance for your help!