Looking for help with Solidworks

[mmganga]

Hello,

I am helping a friend of mine convert a file for manufacturing; I've not worked with SolidWorks before (other than opening files/etc.) but I need somebody to help us with a simple job:

(1) we have a general concept drawing made up of a part (this is not in solidworks);

(2) we have a set of (xyz) coordinates for the part;

(3) we'd like to obtain the same part as an IGES or similar part to send to manufacturing.

Anybody who can help, we'd be very grateful! Depending on the complexity we could also pay some small amount as well.


Thanks so much!

 

[DerrickH]

Have you found a solution to your problem yet?

Derrick Hochgesang
Specials Project Engineer