Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Load vs Extension Curves Comparison

Status
Not open for further replies.
weisusu

weisusu

Bioengineer
Joined
Sep 19, 2008
Messages
26
Location
US
I am comparing two designs by evaluating the load vs extension curves. I want to show that the new design is equivalent or better than the old design. How can I accomplish the comparision by comparing two load vs extension curves?
 
Sort by date Sort by votes
Overlay them on top of each other and circle the section of interest.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mgilbertson
  • Question Question
PLF Load based on 16" spacing
Replies
3
Views
7K
Ron247
Ron247
RampPusher
  • Locked
  • Question Question
Floating Dock Tilt Under Live Loads
Replies
2
Views
995
3DDave
3DDave
Al James at General Atomics
  • Locked
  • Question Question
How can I get a good comparison between CETOL-6sigma versus 3DCS Tolerance software?
Replies
1
Views
1K
IRstuff
IRstuff
Connor Ferster
  • Locked
  • News News
Using Jupyter Notebooks vs Excel for Engineering Calculations
Replies
3
Views
883
Celt83
Celt83
rc0213
  • Locked
  • Question Question
Make Vs Buy Excel Spreadsheet
Replies
2
Views
640
rc0213
rc0213

Part and Inventory Search

Sponsor

Back
Top