biw01
Automotive
- Dec 31, 2011
- 152
Hello Everyone,
I have a custom Drawing Template and its corresponding PAX file in a custom folder outside the NX installation folder. I am launching an NXOpen application using run_managed. I would like to use this Drawing template within the application but it is throwing an error. I am also setting all the Environment Variables to read the custom folder. This is the same thing that happens when I try to custom launch NX.
Can someone let me know how we can load custom templates using run_managed and NXOpen?
Thank you,
Amitabh
I have a custom Drawing Template and its corresponding PAX file in a custom folder outside the NX installation folder. I am launching an NXOpen application using run_managed. I would like to use this Drawing template within the application but it is throwing an error. I am also setting all the Environment Variables to read the custom folder. This is the same thing that happens when I try to custom launch NX.
Can someone let me know how we can load custom templates using run_managed and NXOpen?
Thank you,
Amitabh
