I've got Ling Electronics Shaker LS-100. Unfortunately I've no any documentation about. In particular I'm interestin for interface to connect shaker to the amp. Please help!
I'm new here in the forum but no beginner in research I've already written to the company. The problem is, no answer till now :-( I you have information about shaker it will be very helpful! Thank you
"I'm interestin for interface to connect shaker to the amp"
Isn't there already a cable for that? Or are you planning on using someone else's amp? If so, I would generally advise against that, since the amplifier and shaker are designed to work together.
I ufortunately there is no additional equipmet at all (no cable, no amp. I have power 4-quadrants-amp 26000W I can use for shaker control. I also have dif. acceleration sensor to measure actual acceleration value for closed loop control. To do this I need pin assignment and maximum ratings for current.
OK, how many termiinals does it have? Does it have an internal cooling fan?
I see from that pdf it is a smallish one, externally cooled. Therefore the only connections are across the speaker coil, and possibly an earth, and possibly a no-airflow sensor. A techie with a ohm meter will be able to sort you out on all that.
I'm amazed you are getting no response from Ling.
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
Ling Electronics is not existing any more. The company was bought from Data Physics. They produce similar shaker LE-LS70. I attached info I got. The shaker buid up of two coil that connected inside. The connector have vour upper pins and two lover are jumpered. Thank you all for help!