I'm used to using phantom lines for detail circles and boundary of a detail view. Unless I missed it, I'm not seeing it in ASME. In Y14.3 (2003), they do show an example in figure 23 which shows the detail circle to be phantom, but I don't see any text specifically requiring it. Is there a standard, or at least a best-practice?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
line font for detail circles
- Thread starter TWJR
- Start date
CheckerHater
Mechanical
The figure in the standard IS the standard.
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question