Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Limits and Fits callout in annotation callout

Status
Not open for further replies.

APLTN

Automotive
May 21, 2013
1
Greeting!

I was curious if you can get limits and fit (ex; H7/g6 +/-.00XX) in the annotation call-out tool. You can use this in a normal smart dimension, I'm familiar with that. However, in the annotation tool I have my preferred presets saved for my hole callouts (%HC) and it would be nice if I can throw on limits and fits with having to use smart dimension.

Any ideas??

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor