Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lime Valve Sleeve Material

Status
Not open for further replies.

obsy

Mechanical
Joined
Dec 6, 2004
Messages
5
Location
AU
Hi there,

I'm fresh out of uni and pretty green, so please help.

I have a 25mm (1") pinch valve on a lime slurry (milk of lime) pnematically actuated with a full-on, full-off operation. The problem is the pinch valve sleeve is being corroded to quickly and spliting too soon.

I'm trying to extend the life of the sleeve.

I'm not exactly sure what it's made of but it says something about it being made of 'Nitrile'....?

Have anyone done research into the best material and design of the sleeve?

Any guidance would be greatly appreciated.

Also, I am also open to a change in valve type but apparently not many suitable valves are made that small.

Thanks
Mark O
 
Pure Gum Rubber (PGR) and Polyurethane are frequently offered for abrasive services. Nitrile is also commonly known as Buna-N and is generally applicable with OK abrasion resistance and good resistance to VOCs, and it's inexpensive, too. Butyl rubber would also be worth looking at, since it is pretty abrasion-resistant when used in tires.

Take a look here:
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top