Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lifting

  • Thread starter Thread starter alfordtp
  • Start date Start date
Status
Not open for further replies.
A

alfordtp

Guest
Instead of modeling the entire assembly, I modeled the top sheet that holds the assembly and assigned a mass at the centroidwith four springs with infinite spring constant to represent the weight of the system. Then I added a gravity load.


How do I constrain the assembly if I want to "lift" itfromfour other holes in the top sheet?


Thanks
 
Status
Not open for further replies.

Similar threads

corsa007
  • Locked
  • Question Question
Contact analysis of lifting pin in hole
Replies
1
Views
460
jvian
jvian
F
Mechanism constraint for lifting eqp
Replies
0
Views
3K
fuadpsycho
F
S
door lifting mechanism
Replies
2
Views
4K
sekar_mech02
S
A
Lifting analysis in mechanica
Replies
2
Views
3K
alfordtp
A
S
  • Locked
Simulating Lifting?
Replies
5
Views
4K
atlarson
A

Part and Inventory Search

Sponsor

Back
Top