Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lenght of arc in 2d mode

Status
Not open for further replies.

anoc

Computer
Apr 14, 2003
22
FI
How do I get the lenght-dimension of arc in inventor 6 drawing(Sheet, not in 3D sketch) -mode from some object including arc / circle / half circle?
What tool and how should I click to get it?
 
Replies continue below

Recommended for you

normal dimension tool.

click arc, then before you place the dimension right click and choose "arc length" from the "dimension type" list...
 
Thanks!
I don't understand why the dimension doesn't always show, after pressin the "lenght arc" option. It worked in a new part, but not in old, maybe it's coz of the old part was created with Inv5

Problem solved, thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top