Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
lathe coldchester
- Thread starter maxtar
- Start date
yes maxtar, it is possible. however, it is extremely illegal and i do not recommend that you try it. i personally no of a case where this was done with mastercam and the individual involved was fined severly for doing so. there are copyright laws that prevent you from doing this.
sorry
sorry
- Status
Similar threads
- Locked
- Question
