large information window

[NikonF6]

UG 7.5, part modeling
whenever I change something a large information window pops on the screen. It was not that but I made some change and now cannot remove it.
How I can remove information window...

Thanks

 

[JohnRBaker]

When you say "How I can remove information window..." are you asking how to prevent it from opening or once open, how to get rid of it? In the case of getting rid of an Information Window once it has been opened is by simply selecting the 'X' box in the upper Right-corner of the window, like any other window. If the question is how to prevent it from appearing in the first place, that depends on what function if causing the indo window to open in the first place. What are you doing when this window opens?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[NikonF6]

Thanks John. I want to remove it permanently, not by X.
When I change dimension in sketch and press enter, it comes on the screen.
When want mass of the part it comes on the screen showing mass and many other things...

 

[cowski]

In some dialogs (measure body included) there is an option "show information window"; this may have been turned on the last time you used the command. When you press [kbd]OK[/kbd] or [kbd]Apply[/kbd] when this option is checked, "dialog memory" will store the preference and use it the next time you run the same command. The next time you use such a command, make sure to turn off the "show information window" option before pressing OK.

As for the window showing up after you make a change to a sketch dimension, I'd guess this is an update report. You can turn it off (part specific) in Preferences -> modeling -> update -> generate warning/failure report after update. You can also turn this off in your template part(s) (if you use them) and/or the customer defaults to affect new files created.

www.nxjournaling.com

 

[NikonF6]

it works
Thank you a lot