Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

LABVIEW

Status
Not open for further replies.

2DESIGN02DESIGN

Mechanical
Joined
May 7, 2003
Messages
1
Location
US
Greetings

I have a LabView VI. I can't seem to concentrate my read out to my two inputs. The VI reads all eight channels. How do I specify the two channels I am using for a Load Cell and a Strain Gage.

Thanks,

Rony

 
You might want to cross-post this to the General Engineering Computer Programs Discussion board (forum724) If you don't get any responses here.

Ray Reynolds
Senior Designer
Read: faq731-376
"Probable impossibilities are to be preferred to improbable possibilities."
 
You need to specify a bit more about your VI. Are the channels being displayed in a plot or are they just simple numeric controls? If they are simple controls you can right click on the display readout and hide the display. However I'm betting that it wouldn't be that easy. Any more info would help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top