LABVIEW

[2DESIGN02DESIGN]

Greetings

I have a LabView VI. I can't seem to concentrate my read out to my two inputs. The VI reads all eight channels. How do I specify the two channels I am using for a Load Cell and a Strain Gage.

Thanks,

Rony

 

[MadMango]

You might want to cross-post this to the General Engineering Computer Programs Discussion board (forum724) If you don't get any responses here.

Ray Reynolds
Senior Designer
Read: faq731-376
"Probable impossibilities are to be preferred to improbable possibilities."

 

[FredGarvin]

You need to specify a bit more about your VI. Are the channels being displayed in a plot or are they just simple numeric controls? If they are simple controls you can right click on the display readout and hide the display. However I'm betting that it wouldn't be that easy. Any more info would help.