Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

knurling on a flat surface

  • Thread starter Thread starter uw153
  • Start date Start date
Status
Not open for further replies.
U

uw153

Guest
Does anyone have a good technique for putting a knurl on a flat surface? It is a simple 45 deg. diamond pattern but I can't seem to get it to stay withing my curve boundry.
 
uw 153 -

In this forum if you go to files>select other models>select 31-60. Its a round diamond pattern but still good example to use.

Thanks

AS
 
Status
Not open for further replies.

Similar threads

shanemolloy
  • Locked
  • Question Question
Replacing a component in an assembly based on excel
Replies
0
Views
377
shanemolloy
shanemolloy
S MORIN
  • Locked
  • Question Question
ptc_material_description in a note
Replies
0
Views
1K
S MORIN
S MORIN
whatev-nvm
  • Locked
  • Question Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
1K
whatev-nvm
whatev-nvm
dkakth
  • Locked
  • Question Question
dependency on import ?
Replies
1
Views
421
3DDave
3DDave
freerangequark
  • Locked
  • Question Question
Control of a dimension or parameter in simplified rep?
Replies
1
Views
2K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top