Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

just new to pro/mech

  • Thread starter Thread starter xcad
  • Start date Start date
Status
Not open for further replies.
X

xcad

Guest
I have just installed pro/mech in my computer, but i discover that iam able to run only the Independent mode and when i am trying to load pro/mech inside proe Wildfire, proe comes with an answer :

Application MECHANICA is not supported on this platform.



i would appreciate if anyone could quide me so i could be able to load the integrated mode of mechanica



Karavasilis
 
Are you using LINUX ?
 
We had a similar message recently - the reason: the Mechanica folder was not specified correctly in the Pro/E startup (you can do this via ptcsetup.bat)
 
its true :) but here is a good cut n paste. this worked a treat




ok


here it is :)


pro-setup file..





then cycle throught till u get to the menu where it asks u about


intralink and mechanica





then in the mechanica just point to the install directory





j:\mechanica_wf\











thanks to all those who helped
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top