PrintScaffold
Mechanical
Greetings all!
Some people on older NX6 system asked to help with import of points into their files. I found the journal on this forum (attached to post), and it works superbly, but with only one exception: it regards coordinates as absolute, without regard to the position of the WCS. How can it be modified to put points relative to the WCS? Can please somebody with the knowledge of journalling help us?
Some people on older NX6 system asked to help with import of points into their files. I found the journal on this forum (attached to post), and it works superbly, but with only one exception: it regards coordinates as absolute, without regard to the position of the WCS. How can it be modified to put points relative to the WCS? Can please somebody with the knowledge of journalling help us?
