Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Joining layers

Thread starter ScottMf
Start date Aug 25, 2004

Status: Not open for further replies.

Aug 25, 2004

ScottMf

Mechanical

I am using shell99 elements to model a fiberglass circuit board with adhesive and aluminum heatsink layers around the outside edge on the top of the board. I create the board layer separate from the top two layers, but mesh them all such that the nodes match up. when I then do a modal analysis the board and adhesive seem to connect on the outside edge, but not at any of the other nodes. is there any way for me to get them to connect at all coincident nodes? If not would it make sense to create all 3 layers at once and then use EKILL on the elements that I do not want?

Thanks,
Scott