Hi again!
I do not use Creo/ProE's renderers very often since my main renderer, OctaneRender, is an external one which is far superior. But it also requires far more setup time. From time to time I DO like to do a quick render test with Photolux inside Creo. The problem is that I cannot find out how to get rid of the jagged edges to shadows when "Enable Shadows" is turned on, and softness is something other than zero. It's horrible (please see attached image).
It looks like a quality issue, but any of the parameters for setting up the render do not affect this.
What the heck is wrong?!
I do not use Creo/ProE's renderers very often since my main renderer, OctaneRender, is an external one which is far superior. But it also requires far more setup time. From time to time I DO like to do a quick render test with Photolux inside Creo. The problem is that I cannot find out how to get rid of the jagged edges to shadows when "Enable Shadows" is turned on, and softness is something other than zero. It's horrible (please see attached image).
It looks like a quality issue, but any of the parameters for setting up the render do not affect this.
What the heck is wrong?!