Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Jacket design in COMPRESS

Status
Not open for further replies.

treemkr

Mechanical
Oct 3, 2006
18
How have users handled jacket design in COMPRESS? Alternately, does COMPRESS have plans to include this capability in future release(s)?

I suppose I could model independently as a vessel, but how would you handle a concave closure at the top?

Any suggestions would be appreciated
 
Replies continue below

Recommended for you

The only way to do it is to set up a separate model. Closure bars have to be handled indepently of Compress.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor