Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
IVED data and NX?
- Thread starter phingerz
- Start date
JohnRBaker
Mechanical
What exactly is 'IVED' data?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
I cannot say. It was mentioned when also referring to ECAD and MCAD data. I would guess it is a
possible generic format to bring electrical routing or some PCB layout data into UG-NX. Just wondering if anyone else had heard of it. Thanks for your reply!!
possible generic format to bring electrical routing or some PCB layout data into UG-NX. Just wondering if anyone else had heard of it. Thanks for your reply!!
- Status
