Hi,
My simulation concerns element stamping.
I've defined my material in a tabular way (Yield Stress, Plastic Strain, Rate, Temperature).
When I try to display material strain rate (ER), the results looks completely random.
It doesn't matter if I display max. in-plane principal, min in-plane principal, max principal, other.
I've tested every possible option including top, bottom and middle layer and ER always looks random.
I'm expecting higher values in the bending radius area.
Any advice what the reason can be would be precious
/majim
My simulation concerns element stamping.
I've defined my material in a tabular way (Yield Stress, Plastic Strain, Rate, Temperature).
When I try to display material strain rate (ER), the results looks completely random.
It doesn't matter if I display max. in-plane principal, min in-plane principal, max principal, other.
I've tested every possible option including top, bottom and middle layer and ER always looks random.
I'm expecting higher values in the bending radius area.
Any advice what the reason can be would be precious
/majim