Mandrill22
Mechanical
I have a tapered hole at 4 degrees, no thread, just 6mm dia and 1mm deep.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ISO Tapered Hole Callout
- Thread starter Mandrill22
- Start date
- Status
CheckerHater
Mechanical
And?
"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future
"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future
- Thread starter
- #4
Mandrill22
Mechanical
Sorry, I was asking how to call it out per ISO drafting specs.
- Status
Similar threads
- Question
- Question
