Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ISO Standard for General Notes on Drawings
- Thread starter 3D_CADman
- Start date
CheckerHater
Mechanical
What exactly you mean by "more than one set of general notes"?
2 sets of notes to contradict each other on face of the same drawing?
ISO today is not very fond of text notes, aiming at system of symbols that will cover all you needs without using any particular language.
I am not sure how long it is going to take, but until it happened, I believe you can arrange your notes any way that works for you.
"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future
2 sets of notes to contradict each other on face of the same drawing?
ISO today is not very fond of text notes, aiming at system of symbols that will cover all you needs without using any particular language.
I am not sure how long it is going to take, but until it happened, I believe you can arrange your notes any way that works for you.
"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question