Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is this callout practical?
- Thread starter cmmguy75
- Start date
- Thread starter
- #2
You seem to have posted the same figure twice
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
- Thread starter
- #4
Both are usable, though using holes as locating features individually like that can produce sequences of unwanted tolerance buildup. If the process is capable, just use a position tolerance to A for all of them and a profile of the part to A for the perimeter. It's one setup in the CNC machine, which means there is one frame of reference when it's made.
- Status
Similar threads
- Locked
- Question