I am looking for a newer GUI based program that will allow me to manipulate .job files that were created in Cadkey's Cutting edge program which is a DOS based program. If there is a program out there that will allow me to do this, or if there is an import function within Cadkey19 it would save a ton of down time switching from windows to DOS. CAN ANYONE OFFER ANY INSIGHT.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is there a program that is GUI based that will manipulate .job files
- Thread starter witty
- Start date
Similar threads
