Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is there a 'gang mate' in SW? 2
- Thread starter skilet17
- Start date
-
1
- #2
CorBlimeyLimey
Mechanical
Not if you have already inserted the bolts & nuts. However if you insert one nut & bolt & then make a Component pattern of them they will be aligned to the "seed" parts.
![[cheers]](/data/assets/smilies/cheers.gif "[cheers] [cheers]")
-
1
- #3
Also look into "Mate Reference" mates on the hardware models, and if you use Hole Wizard to create hole patterns, you can tie that to Component Patterns for your hardware.
[green]"But what... is it good for?"[/green]
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
[green]"But what... is it good for?"[/green]
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
- Status