I am wondering is there any way to have solid edge list your finish diminsions on the BOM? I know I can set this up in property manager, but I would have to key in the sizes manually. If I can set it up with the variable table then my information would update if a change was made. Is this possible or am I dreaming?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is it possible to have SE to list finish dim on BOM?
- Thread starter scobb1
- Start date
It is possible, but I think only with programming. This has been discussed numerous times in the SolidEdge newsgroups. I'll take a look there and get back to you Monday-ish if no one has answered here first.
--Scott
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
--Scott
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
- Status
Similar threads
- Locked
- Question
- Locked
- Question