Is it possible to have SE to list finish dim on BOM?

[scobb1]

I am wondering is there any way to have solid edge list your finish diminsions on the BOM? I know I can set this up in property manager, but I would have to key in the sizes manually. If I can set it up with the variable table then my information would update if a change was made. Is this possible or am I dreaming?

 

[swertel]

It is possible, but I think only with programming. This has been discussed numerous times in the SolidEdge newsgroups. I'll take a look there and get back to you Monday-ish if no one has answered here first.

--Scott

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.