I am wondering you use any diametral pitch (DP) value when designing a shaft and hub involute spline system based on the ANSI B92.1 - 1996 standard. If so, how do yo calculate the machining tolerance and permissible effective variation when using a DP value that is not defined in the standard.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Involute spline
- Thread starter vaslava
- Start date
Similar threads
