Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Involute Spline on shaft and hub

Status
Not open for further replies.
cadmate

cadmate

Mechanical
Joined
May 5, 2005
Messages
84
Location
GB
Hello all, no matter what settings I try, I always fail to produce a spline in a hub bore using the connection generator. I can get the spline into the shaft, but not the hub. Is there tutorial for this, using inventor 2008 pro.

Thanks in advance
 
Status
Not open for further replies.

Similar threads

Starker
  • Locked
  • Question Question
iProperty Function That Displays String Depending On Boolean
Replies
0
Views
802
Starker
Starker
kevc70
  • Locked
  • Question Question
Saving Title Block and Border in AutoCad Inventor
Replies
1
Views
434
TuanTH
TuanTH
E
Why the Tube and Pipe fittings at Content Center doesn't have iMates?
Replies
0
Views
6K
EdsonPaschoal
E
E
New to the forum, question about a pin and slider joint
Replies
0
Views
6K
EightballRider8
E
Jack Henriques
  • Locked
  • Question Question
Question for any MEs working on PCB designs
Replies
0
Views
249
Jack Henriques
Jack Henriques

Part and Inventory Search

Sponsor

Back
Top