Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Involute Form in Sketch

Status
Not open for further replies.
fred2002

fred2002

Mechanical
Joined
Mar 6, 2002
Messages
36
Location
GB
Does anybody know how to create an involute gear tooth profile in a UG sketch? I'm currently using v18 and haven't got access to the GTAC.

Thanks
 
Sort by date Sort by votes
The following link should take you to an explanation of how to do it in a different modeling product. You can probably just cruise by the step-by-step, but understand how they are using the math to build the profile, then translate to sketcher.


Terry
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Jashe
  • Question Question
Sketch Failure Message in NX
Replies
3
Views
2K
Jashe
Jashe
CAD2015
  • Locked
  • Question Question
NX Sketch dimension.....
Replies
2
Views
2K
CAD2015
CAD2015
CAD2015
  • Question Question
Sketch dimension shown on drawing..............
Replies
2
Views
2K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
NX 2212 - SKETCH message
Replies
2
Views
1K
CAD2015
CAD2015
multicaduser
  • Locked
  • Question Question
sketch fill pattern
Replies
1
Views
818
multicaduser
multicaduser

Part and Inventory Search

Sponsor

Back
Top