Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor R5 crashing???

Status
Not open for further replies.

Tokugawa

Mechanical
Jun 13, 2001
6
US
Inventor seems to kick me out every time I save a part file, close it, and then try to open a new part file. Does anyone else have this problem?
 
Replies continue below

Recommended for you

What version are you using? Have you installed the service packs? When I started on 5.3 it crashed all the time, but the service pack has fixed that.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top