Inventor Mold Design

[bimbo666]

Hi Guys,

Did someone of you hear something about the new mold module on Inventor, I´m currently using UG Nx, and Proe Wildfire, because had a lot of problems when try to design a very simple mold with Inventor, so maybe one of you had better luck than me to design molds with Inventor, and try to explain me wich is the best way to do it, or if using add-ind , wich are they

Pablo Ulloa

 

[zachary_popov]

I'm not familiarwhether a mold module for Inventor exists, but for a relatively easy mold design you could experiance the inventor technique for derived part and asemblies.