Invalid part tag

[Carlosmurilo]

Hi All,

I have a question about drafting. I changed the part model and after that when i was open the file drafting show this message "INVALID PART TAG". Could someone help me?

regards
Carlos

 

[mousepotato]

Hi,

Do you have crosshatches or section views? Just expand the views (with crosshatches), remove the boundaries of the cross hatches and then the croshatches themselves. Come out of the expanded view mode and proceed to replace the part. Now if it doesn't fail recreate the crosshatches again... Give it a try

Regards,
mousepotato

 

[JohnRBaker]

And if this doesn't help, try contacting GTAC and have them look at your part file(s).

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Carlosmurilo]

Friends,

The problem was solve. I copied a section view from other drawing. This is the wrong way.

Thanks

Carlos