On using Contour Flange or Flange in Sheet Metal, I'm getting an error message, "Invalid Bend Param Value", or "Invalid Bend Param Type". I'm not doing anything different to normal and it works on a second PC. The Sheet Metal templates are exactly the same. Anybody know what the problem is?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Invalid Bend Param Value
- Thread starter goagerbil
- Start date
Similar threads
- Locked
- Question