TomFlyer
Aerospace
- Feb 26, 2005
- 7
I have a memory access violation when trying to print either to my desktop printer or Adobe PDF while in Drafting. I like to generate a quick-and-dirty hardcopy of operation sheets using the 'Print' command in NX4. Executing the command generates an error titled: "Entering Drafting. Internal error: Memory access error." However, I can Plot these sheets, but with an HP2500 Postscript printer, this takes a while.
I've gone so far as to install another hard drive, install XP and UGNX4, configure UG to my liking, and this will result in everything working correctly. Putting the original drive back into the machine results in the memory error again.
Has anyone had any experience with perhaps some conflicting software or setup that gives this error?
My system is an Intel 2.4 GhZ P4 on an ASUS P4V800D-X MB with 2 GB RAM, nVidia FX1300 128MB video card and UGNX4.0.2.2
Any help would be appreciated.
Tom Flyer
Smiths Aerospace Components
I've gone so far as to install another hard drive, install XP and UGNX4, configure UG to my liking, and this will result in everything working correctly. Putting the original drive back into the machine results in the memory error again.
Has anyone had any experience with perhaps some conflicting software or setup that gives this error?
My system is an Intel 2.4 GhZ P4 on an ASUS P4V800D-X MB with 2 GB RAM, nVidia FX1300 128MB video card and UGNX4.0.2.2
Any help would be appreciated.
Tom Flyer
Smiths Aerospace Components
