My question is reguarding LMC position of corner Radius on an internal square feature. The feature is dimensioned (for example) 12.000 x 12.000 +-.005 with a 1.50 +-.02 Rad.(4x). The dwg. is to be interpreted per ASME Y14.5M. The resultant condition of the feature is 12.004 x 12.004 and the corner R's are 1.500. However at the points of tangency the R's overcut slightly giving the measurement of 12.010. I have not had any success finding a proper interpretation of this condition in ASME 14.5M-1994. Can the R's overcut up to the default .XX tol. for position?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Internal Corner Radius Overcut
- Thread starter jsprague
- Start date
Similar threads
- Locked
- Question
- Locked
- Question