Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

installation, startup and commissioning of generators

Status
Not open for further replies.
rQuestionEngineering

rQuestionEngineering

Mechanical
Joined
Aug 30, 2012
Messages
205
Location
MY
Can anyone share the time line and duration for a gas turbine generator installation and commissioning ?

From boxes receiving, skid positioning, pre-alignment, oil flushing, loop check, final alignment, pre-com , startup and commissioning.
Is this sequence correct ?
 
Status
Not open for further replies.

Similar threads

aegis4048
  • Locked
  • Question Question
Timing gear ratio and number of female vs. male lobes for rotary screw compressors
Replies
1
Views
3K
aegis4048
aegis4048
macabihaifa
  • Locked
  • Question Question
MATERIALS OF CONSTRUCTION RECIPROCATING COMPRESSORS
Replies
1
Views
2K
SB1976
SB1976
rQuestionEngineering
  • Locked
  • Question Question
Steam turbine and compressor name plate code
Replies
3
Views
2K
pierreick
pierreick
Y
  • Locked
  • Question Question
Formula source of flow capacity of pressure relief deives for gas cylinders in CGA S 1.1 -2019
Replies
3
Views
3K
yanxingqing
Y
Amjad Ali
  • Locked
  • Question Question
New Member Introduction and Learning Phase
Replies
0
Views
476
Amjad Ali
Amjad Ali

Part and Inventory Search

Sponsor

Back
Top