Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
inspection fixture
- Thread starter connery
- Start date
hi
use one round pin and a diamond pin to locate the part to be tested preferable at oppsit ends of the part then bore holes in the fixture exactly where the the rest of the holes should be, then make sliding pins with the ends turned down to the sum of the mmc of the hole and the location tolarence. Your pin gage end will be smaller by the sum of these deninsions.
Any hole that your pin will not enter is eigther out of location or under size if the later is true then you can open the hole to lmc and recheck.
use one round pin and a diamond pin to locate the part to be tested preferable at oppsit ends of the part then bore holes in the fixture exactly where the the rest of the holes should be, then make sliding pins with the ends turned down to the sum of the mmc of the hole and the location tolarence. Your pin gage end will be smaller by the sum of these deninsions.
Any hole that your pin will not enter is eigther out of location or under size if the later is true then you can open the hole to lmc and recheck.
- Status
Similar threads
- Locked
- Question
- Locked
- Question