M
maurya
Guest
To insert a Geometric Tolerance symbol in a NOTE as a parameter follow this procedure...
&g<ID>
Where <ID>is the number denoting the order in which the GTOL (you are going to insert) was created. You can find this number by choosing Info-> Switch dimensions.
You can modify the GTOL from the NOTE also, to do so click on the GTOL symbol in the NOTE, any chnges you made will be reflected to the original.
Edited by: maurya
&g<ID>
Where <ID>is the number denoting the order in which the GTOL (you are going to insert) was created. You can find this number by choosing Info-> Switch dimensions.
You can modify the GTOL from the NOTE also, to do so click on the GTOL symbol in the NOTE, any chnges you made will be reflected to the original.
Edited by: maurya
