Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Insert dimensions into a drawing
- Thread starter Pachem
- Start date
No there is no option anywhere to Turn off this function. Only and RMB uncheck "Mark for Drawings". You might be able to create a Macro that would turn this off for every dimension after the model is completed.
Regards,
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
Regards,
Scott Baugh, CSWP
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question