Hi, I have one Arburg injection moulding machine. Currently i have one inadequate chiller tryig to cool the hyraulics. But as our mould become more complex i will need to introduce cooling for the mould. Any tips for what type of cooler i should use for the hydraulics, and what i should use on the mould? I'm new to this so any avice is greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Injection Mouling
- Thread starter Mtronics
- Start date
One of the plastics forums may be a better place to ask.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
MikeHalloran
Mechanical
Industrial hydraulics are normally cooled by a radiator of sorts,
which works better if the fan is actually rotating,
and if you clean the accumulated shop crud out of the fins.
Tell us if that's not your problem, and we'll work from there.
Mike Halloran
Pembroke Pines, FL, USA
which works better if the fan is actually rotating,
and if you clean the accumulated shop crud out of the fins.
Tell us if that's not your problem, and we'll work from there.
Mike Halloran
Pembroke Pines, FL, USA
- Status
Similar threads