Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Info on Sizing Positive Clutches??

Status
Not open for further replies.
rb

rb

Mechanical
Joined
May 14, 1999
Messages
7
Location
CA
I need a positive clutch to transmit torque in both rotational directions with minimal play. I am looking at designing a v-shaped tooth postive clutch to do the job.

Can anyone point me to a reference on sizing a V-tooth positive clutch?

Thanks!
Ralph
 
Status
Not open for further replies.

Similar threads

Mow guy
  • Locked
  • Question Question
Sizing a 1to1 90 degree gearbox
Replies
4
Views
517
Mow guy
Mow guy
Kishor Ponde
  • Locked
  • Question Question
Calculate the torgue on gear? Design the ring gear
Replies
1
Views
423
dvd
dvd
BD5_MxExp
  • Locked
  • Question Question
Spline Data: DIN 3960 Inspection Information
Replies
2
Views
660
mfgenggear
mfgenggear
MRSSPOCK
  • Locked
  • Question Question
23 degree pressure angle on stub teeth ???
Replies
4
Views
512
spigor
spigor
SMKRe
  • Locked
  • Question Question
Centrifugal effect on gear teeth of solid gears
Replies
1
Views
281
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top