S
Simao Câmara Manoel
Guest
Hi guys
I have a question about the gyroid/giroyd infill …(this infill, exists in Ultimaker Cura) I am working a piece for manucfaturing and i choose this infill because of their properties but its really hard to produce the same infill (gyroid) in Solidworks to testing the strenght of the piece
There any way to do that? Because Solidworks can´t load the piece with this infill and i needed to test
Thanks guys
Simão Manoel
I have a question about the gyroid/giroyd infill …(this infill, exists in Ultimaker Cura) I am working a piece for manucfaturing and i choose this infill because of their properties but its really hard to produce the same infill (gyroid) in Solidworks to testing the strenght of the piece
There any way to do that? Because Solidworks can´t load the piece with this infill and i needed to test
Thanks guys
Simão Manoel
