rkm502
Mechanical
- Dec 27, 2008
- 5
Hello -
I am doing pressure vessel calculations on vertical vessels. I have an inlet nozzle that is tangential to the shell and inclined. It is a complicated connection that results in a lot of material being removed from the shell. I have always used APV to perform my vessel calcs. The most recent release of APV won't allow me to run this configuration, which makes me question if I've been doing it incorrectly all along. I am looking for any advice/experience with this type of nozzle connection. Thanks.
I am doing pressure vessel calculations on vertical vessels. I have an inlet nozzle that is tangential to the shell and inclined. It is a complicated connection that results in a lot of material being removed from the shell. I have always used APV to perform my vessel calcs. The most recent release of APV won't allow me to run this configuration, which makes me question if I've been doing it incorrectly all along. I am looking for any advice/experience with this type of nozzle connection. Thanks.