Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

*Importing material state and transferring results*

Status
Not open for further replies.

mmmbordo643

New member
Joined
Feb 24, 2006
Messages
31
Location
US
Hello everyone,

I am trying to transfer the material state at the end of a dynamic, explicit analysis (forming) to a standard static analysis (springback). I am using a modified drucker-prager cap model to account for the nonlinear effects. Is this possible? Also, if the static standard analysis is possible, after the springback i would like to extract the resonance frequencies in another step. However, the initial explicit analysis is axisymmetric as well as symmetric about the xz plane so I have only modeled 1/4 of the total blank. Is there a way to transfer these results to a full 3D model in order to extract the resonance frequencies correctly? Any help is greatly appreciated

Thanks again,

Chris
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top