Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

import/open dwg

Thread starter raysapp
Start date Jul 28, 2010

Status: Not open for further replies.

Jul 28, 2010

raysapp

Aerospace

I tried both importing and opening the attached dwg that I pulled off a tooling component site. It was empty, although certain levels showed an object count. I tried unblanking(show) and select all but still nothing. I tried opening in a different system and the solids showed up no problem, from which I then exported a parasolid.
Since I have what I need its not a big deal, just curious if anyone else can open.
Thanks

Ray S
NX 7.0.1.7

http://www.appliedprecisionproducts.com